Boonton - Resource Library

Noisecom > Videos

Noisecom CNG-EBNO 70 Demonstration at IMS 2016 Precision Carrier to Noise for Satellite

Broadcasted 6/6/2016

Measuring accurate Carrier to Noise of a particular carrier in a multi carrier Satellite IF Band

See More

Demo of a Boonton USB Sensor and a Noisecom UFX7000 to measure Carrier to Noise (C/N) of a pulsed signal

Broadcasted 6/6/2016

This demonstration shows how you can change and measure the Carrier to Noise (C/N) of a pulsed radar or pulsed communication signal. This is use full for showing receiver sensitivity or jamming a signal.

See More

Noisecom J9005 Demonstration at Design Con 2016

Broadcasted 1/27/2016

Emulate AWGN channel on 10GBase signal by adding analog broadband (5 GHz) additive white Gaussian noise (AWGN) on differential data lines using J9010.

See More

Noisecom CNG-EbNo Series Demonstration

Broadcasted 6/2/2015

Noisecom's CNG-EbNo series allows system, design, and test engineers in the telecommunications industry to use a single tool to generate precision signal to noise ratios.

See More

Testing Effect of Noise & Spurs on Vcc of a PLL/VCO integrated circuit

Broadcasted 7/17/2014

In this short video clip we show how a designer or verification engineer can easily test effects of noise and spurs riding on the Vcc of their PLL/VCO circuit. We baseline the PLL/VCO phase noise performance with no noise (AWGN) or spurs (CW tones) injected. We then introduce broadband noise to the Vcc and repeat phase noise measurements to see impact of AWGN. The measurements are repeated for 10 KHz, 100 KHz, 1 MHz and 10 MHz CW tones. The test set-up consists of a clean power supply, JV9000 noise on Vcc test solution, PLL/VCO eval board (DUT) and a phase noise analyzer (BNC model 7300). The simplicity of the testing shown in this video highlights the advantages of using an integrated solution like JV9000 where a noise generator, a CW signal generator and combiners, attenuators and bias-t are all integrated into one box allowing noise immunity testing within minutes.

See More

Testing Effect of Noise on Vcc for serial data communications

Broadcasted 4/10/2014

This short video clip demonstrates the impact of noise and spurs on Vcc of an IC for high speed serial data communication IC. For this demonstration we generate pseudo random data clocked at 1.6 GHz using a BERT. Onto the high speed differential signal path we introduce Noisecom’s J7000 random jitter generator which takes in the differential serial data and adds AWGN noise to it. The output of J7000 then drives a data/clock buffer IC as a DUT (see diagram below). The Vcc of the IC is connected to the JV9000, our noise on Vcc test solution that introduces noise and spurs on the Vcc supply voltage an IC. The output of the IC is terminated at the detector inputs of the BERT for BER and eye diagram analysis.

See More

Noisecom JV9000A

Broadcasted 1/19/2012

Modern integrated circuits contain billions of transistors that require complex power distribution systems. This power distribution complexity combined with inexpensive switch-mode power supplies creates several sources of noise found on the power and ground planes of a PC circuit board. The Noisecom JV9000A is designed to generate random and deterministic noise on the power and ground planes to emulate this behavior. This video is an example of how the JV9000A can be used to generate these effects.

See More